Lynx Studio Technology
home products news & events support how to buy company contact
Search
Support Center
Downloads
Contact Tech Support

Frequently Asked Questions
Aurora
LynxONE
LynxTWO/L22
Lynx AES16 / AES16e
Lynx LS-ADAT / LS-AES
LT-HD

Software Application Notes
Hardware Test Procedures
Connector Pin Outs
Other useful documents
Videos
Support Documents
Support Forum
User Manuals
Register Your Products
Buy Cables Now
Aurora
• Getting Started/Installation
• Troubleshooting
• Operation
• Compatibility


  • Unit will not turn on.
  • Clicking, popping or crackling noises in your audio:
  • Audio plays back at a faster or slower rate than expected.
  • No audio to analog outputs.
  • SynchroLock LED does not illuminate.
  • Output is too loud for my monitoring equipment.
  • The selected Sync Source is flashing, and the INT LED is illuminated.
  • The Sync Source LED is flashing alternately between INT and the selected Sync Source.
  • I’m only getting half as many channels of conversion as expected, and channels are not routed as I would expect.
  • The Aurora Remote Control Software will not open or opens but does not allow parameters to be changed.
  • The Aurora firmware updater fails, reporting "there in no connected Aurora".


No audio to analog outputs.
Check the following elements:
  • Insure that the Cable connected to the appropriate analog output port is the Lynx CBL-AOUT85 or adheres to the Tascam DA-88 Analog I/O pin configuration.
  • Set the Meter Selection button to the appropriate signal source, and verify that there is meter activity on the inputs. Also make sure that the correct signal source is selected for TO ANALOG OUT from the Aurora front panel.
  • Verify that your monitoring equipment is turned on and the levels are turned up to a safe listening level.

Home | Products | News & Events | Support | How To Buy | Company | Contact Us | Employment | Privacy

Lynx on Facebook   Support on Facebook 		© Copyright 2024, Lynx Studio Technology, Inc.