Lynx Studio Technology
home products news & events support how to buy company contact
Search
Support Center
Downloads
Contact Tech Support

Frequently Asked Questions
Aurora
LynxONE
LynxTWO/L22
Lynx AES16 / AES16e
Lynx LS-ADAT / LS-AES
LT-HD

Software Application Notes
Hardware Test Procedures
Connector Pin Outs
Other useful documents
Videos
Support Documents
Support Forum
User Manuals
Register Your Products
Buy Cables Now
Aurora
Getting Started/Installation
Troubleshooting
Operation
Compatibility


  • Unit will not turn on.
  • Clicking, popping or crackling noises in your audio:
  • Audio plays back at a faster or slower rate than expected.
  • No audio to analog outputs.
  • SynchroLock LED does not illuminate.
  • Output is too loud for my monitoring equipment.
  • The selected Sync Source is flashing, and the INT LED is illuminated.
  • The Sync Source LED is flashing alternately between INT and the selected Sync Source.
  • I’m only getting half as many channels of conversion as expected, and channels are not routed as I would expect.
  • The Aurora Remote Control Software will not open or opens but does not allow parameters to be changed.
  • The Aurora firmware updater fails, reporting "there in no connected Aurora".


Unit will not turn on.
Check the following:
  • Is the AC Power Cord securely connected to the AC port on the Aurora, and is it securely connected to a valid, grounded AC Outlet?
  • Check the label by the AC adapter on the back of the Aurora to insure that you are using the correct version for your electrical system. The Aurora is available in 100V, 115V and 230V configurations.
  • Verify that you have pressed the Power Button on the Aurora.

Home | Products | News & Events | Support | How To Buy | Company | Contact Us | Employment | Privacy

Lynx on Facebook   Support on Facebook
© Copyright 2024, Lynx Studio Technology, Inc.