Lynx Studio Technology
home products news & events support how to buy company contact
Search
Support Center
Downloads
Contact Tech Support

Frequently Asked Questions
Aurora
LynxONE
LynxTWO/L22
Lynx AES16 / AES16e
Lynx LS-ADAT / LS-AES
LT-HD

Software Application Notes
Hardware Test Procedures
Connector Pin Outs
Other useful documents
Videos
Support Documents
Support Forum
User Manuals
Register Your Products
Buy Cables Now
LynxONE
• Getting Started/Installation
• Troubleshooting
• Operation
• Compatibility


  • When Windows starts I see a LynxONE Mixer error - "No mixer device drivers are available".
  • I installed the LynxONE in the PCI slot before I ran Setup.exe for Windows 95/98, what do I do now?
  • The meters in the LynxONE Mixer do not show activity when I am monitoring from the analog or digital inputs.
  • The Lynx mixer reports a sample rate of 22k when I first boot into Windows. Why?
  • I cannot record from the LynxONE’s digital input.
  • There is no signal on the digital output during playback.
  • I’m trying to play 96k audio out the digital output, but my application is saying that sample rate is not supported.
  • Audio playback sounds really slow or erratic.
  • Audio playback sounds fast or slow when I am using the digital input as the clock source.
  • My audio output is way too loud.
  • My input signals are too low.
  • I cannot change the Sample Clock Source from Digital in the LynxONE Mixer.
  • When I choose either External or Header as the Sample Clock Source, I cannot select Word as the Sample Clock Reference.
  • When I log into my Windows 2000/XP computer as an Administrator everything works fine. When I log in as a User, I cannot use my LynxONE. When launching the Lynx Mixer, I get an error message: “No mixer device drivers available.”


I installed the LynxONE in the PCI slot before I ran Setup.exe for Windows 95/98, what do I do now?
Windows 9X

The device manager in Windows 95/98 requires the .INF file for a device to be installed before the Plug and Play scan to detect new hardware (which happens on each boot). This is why Setup.exe should generally be run before you install the LynxONE into your computer. To correct this follow the steps listed here:
  1. Load the device manager by clicking on Start > Control Panel > System > Device Manager.
  2. There should be an entry called "+ ? Other Devices" listed about 3/4 down the page. Click on the + sign. "PCI Multimedia Audio Device" should appear.
  3. Click on "PCI Multimedia Audio Device", then click on "Remove".
  4. A "Confirm Device Removal" dialog box should appear, click on "OK". It might take a couple of seconds for this dialog box to close.
  5. Click on "Refresh". After several seconds, a "New Hardware Found" dialog box will appear. Depending on your installation of Windows 95/98, another dialog box may appear asking for setup disk. The location you need to specify is C:\Windows\System Click on "OK" after entering this path.
  6. You may need to reboot your computer once this completes to get everything running properly.

Home | Products | News & Events | Support | How To Buy | Company | Contact Us | Employment | Privacy

Lynx on Facebook   Support on Facebook 		© Copyright 2024, Lynx Studio Technology, Inc.