Lynx Studio Technology
home products news & events support how to buy company contact
Search
Support Center
Downloads
Contact Tech Support

Frequently Asked Questions
Aurora
LynxONE
LynxTWO/L22
Lynx AES16 / AES16e
Lynx LS-ADAT / LS-AES
LT-HD

Software Application Notes
Hardware Test Procedures
Connector Pin Outs
Other useful documents
Videos
Support Documents
Support Forum
User Manuals
Register Your Products
Buy Cables Now
LynxONE
• Getting Started/Installation
• Troubleshooting
• Operation
• Compatibility


  • When Windows starts I see a LynxONE Mixer error - "No mixer device drivers are available".
  • I installed the LynxONE in the PCI slot before I ran Setup.exe for Windows 95/98, what do I do now?
  • The meters in the LynxONE Mixer do not show activity when I am monitoring from the analog or digital inputs.
  • The Lynx mixer reports a sample rate of 22k when I first boot into Windows. Why?
  • I cannot record from the LynxONE’s digital input.
  • There is no signal on the digital output during playback.
  • I’m trying to play 96k audio out the digital output, but my application is saying that sample rate is not supported.
  • Audio playback sounds really slow or erratic.
  • Audio playback sounds fast or slow when I am using the digital input as the clock source.
  • My audio output is way too loud.
  • My input signals are too low.
  • I cannot change the Sample Clock Source from Digital in the LynxONE Mixer.
  • When I choose either External or Header as the Sample Clock Source, I cannot select Word as the Sample Clock Reference.
  • When I log into my Windows 2000/XP computer as an Administrator everything works fine. When I log in as a User, I cannot use my LynxONE. When launching the Lynx Mixer, I get an error message: “No mixer device drivers available.”


The meters in the LynxONE Mixer do not show activity when I am monitoring from the analog or digital inputs.
Windows 2000/XP

This is normal. The meters will show activity only when the card is in record or playback mode while being used with a third party application. If metering is required for monitoring, most applications offer this functionality by simply putting the card in record mode without saving data to a disk file. However, for the lowest latency monitor listening, use the LynxONE’s on-board monitor capabilities.

Home | Products | News & Events | Support | How To Buy | Company | Contact Us | Employment | Privacy

Lynx on Facebook   Support on Facebook 		© Copyright 2024, Lynx Studio Technology, Inc.