Direct monitoring
Printed From: Lynx Studio Technology, Inc.
Category: Lynx Forum
Forum Name: Lynx Support Forum
Forum Description: Discussions about Lynx Hardware & Software
URL: https://www.lynxstudio.net/forum/forum_posts.asp?TID=5302
Printed Date: June/17/2024 at 1:12am
Software Version: Web Wiz Forums 11.04 - http://www.webwizforums.com
Topic: Direct monitoring
Posted By: terence1212
Subject: Direct monitoring
Date Posted: May/21/2014 at 2:11pm
|
I'm waiting for my Lynx Hilo to arrive - the most high end piece of audio equipment I have ever bought. I'm using it for voice over recording and want to be able to monitor directly with zero latency (i.e., so the signal doesn't loop through the DAW (Cubase) first and then back to the headphones). I'm assuming this is simple to do in the Lynx mixer. My previous interface is the Saffire LE, much simpler of course and a no-brainer to monitor directly. With this more pro equipment with so many routing options, I want to make sure I haven't overlooked something before I pay the man. I know it's a really basic question, but can someone hold my hand please!
|
Replies:
Posted By: David A Hoatson
Date Posted: May/21/2014 at 2:41pm
You didn't mention which interface to the computer you ordered, Thunderbolt or USB. Either way you would use Hilo Remote that comes with the driver for those interfaces to setup your zero latency monitoring (or you can do it from the front panel of the Hilo itself - works the same way).
-------------
Thank you,
David A. Hoatson
Lynx Studio Technology, Inc.
Co-founder, Chief Software Engineer
|
Posted By: terence1212
Date Posted: May/21/2014 at 3:51pm
|
Thank you for the rapid response, David. I ordered the USB interface. I will probably set it up from the Hilo interface itself. I think, if I understand the manual correctly, for this scenario there will not be much change from the default settings. For direct monitoring I just need the line in routed to the headphones, right?
|
Posted By: David A Hoatson
Date Posted: May/21/2014 at 4:06pm
Yes. Just select the phones as the current output on the Output Mix Routing Page then turn on the LINE IN. Pretty easy.
-------------
Thank you,
David A. Hoatson
Lynx Studio Technology, Inc.
Co-founder, Chief Software Engineer
|
Posted By: terence1212
Date Posted: May/21/2014 at 4:44pm
|