Two Auroras with LT-USB

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hello,

I'm having trouble chaining two Aurora 8s using the AES i/o, one of them has the LT-USB card.

I can record 16 channels, but when I send audio to outputs 9-16, nothing happens.
Is there a specific configuration I might be missing out?

I tested on Win10 and OSX. My DAW is PT12. Both devices are firmware updated to 28.
Thanks

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
mendozal Members Profile Send Private Message Find Members Posts Add to Buddy List Caracal Joined: April/28/2016 Location: Paraguay Points: 9	Topic: Two Auroras with LT-USB Posted: July/03/2016 at 7:04pm
	Hello, I'm having trouble chaining two Aurora 8s using the AES i/o, one of them has the LT-USB card. I can record 16 channels, but when I send audio to outputs 9-16, nothing happens. Is there a specific configuration I might be missing out? I tested on Win10 and OSX. My DAW is PT12. Both devices are firmware updated to 28. Thanks

mendozal Members Profile Send Private Message Find Members Posts Add to Buddy List Caracal Joined: April/28/2016 Location: Paraguay Points: 9	Posted: July/04/2016 at 1:06pm
	I followed the same steps in this post http://www.lynxstudio.com/forum/forum_posts.asp?TID=6126&KW=chain+lt-fw&PID=33786&title=daisy-chaining-aurora-8-and-16-using-ltfw#33786 With the exception that I don't have a LT-FW but a LT-USB card (so I didn't downgrade the firmware).

PaulTech Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: August/13/2004 Location: United States Points: 5495	Posted: July/06/2016 at 4:54pm
	try these steps: * Run then launch the ARC program. Navigate to DIGITAL I/O and SETTINGS page. * Set TO DIGITAL OUT to "Remote" * For Source A, in the bottom right quadrant, locate the source buttons directly above the faders. * Hold down the CTRL key on the keyboard and select for the first digital channel "LSLOT IN 9" * The sources should change in order, from L9 through L16. If they do not change, select "LSLOT In 9" through "LSLOT In 16" for each channel in order.. Afterwards, close the ARC, and power cycle the Aurora from the front panel switch.
	Paul Erlandson Lynx Studio Technology Support 714-545-4700 x 206 Lynx Support and Updates on Facebook!

mendozal Members Profile Send Private Message Find Members Posts Add to Buddy List Caracal Joined: April/28/2016 Location: Paraguay Points: 9	Posted: July/06/2016 at 6:45pm
	it worked! Thank you!